Difference between revisions of "MV2-01"
Jump to navigation
Jump to search
Line 4: | Line 4: | ||
* Any metal stand offs seen around the edge of the board were use to level the board for scanning. | * Any metal stand offs seen around the edge of the board were use to level the board for scanning. | ||
<br> | <br> | ||
− | |||
{{MvsMotherBoard2Slot|mv2-01|set1}} | {{MvsMotherBoard2Slot|mv2-01|set1}} |
Latest revision as of 02:05, 4 October 2018
A couple notes on the scans:
- This board was a little wider then my scanner and required stitching 2 scans together. The stitching is about an inch in from the right side of each image.
- The battery and BIOS chip were removed.
- Any metal stand offs seen around the edge of the board were use to level the board for scanning.