Difference between revisions of "MV2-01"

From MVS
Jump to navigation Jump to search
 
Line 4: Line 4:
 
* Any metal stand offs seen around the edge of the board were use to level the board for scanning.
 
* Any metal stand offs seen around the edge of the board were use to level the board for scanning.
 
<br>
 
<br>
 
 
{{MvsMotherBoard2Slot|mv2-01|set1}}
 
{{MvsMotherBoard2Slot|mv2-01|set1}}

Latest revision as of 02:05, 4 October 2018

A couple notes on the scans:

  • This board was a little wider then my scanner and required stitching 2 scans together. The stitching is about an inch in from the right side of each image.
  • The battery and BIOS chip were removed.
  • Any metal stand offs seen around the edge of the board were use to level the board for scanning.


board top
board bottom